Connecting Power To The Monitor / Charging Battery; Connecting Power To The Camera - Levana Keera Manuel

SETUP

Connecting Power to the Monitor / Charging Battery

1. Connect the small end of power adapter marked MONITOR
the monitor as shown in the diagram. Connect the other end of the adapter into an available
wall outlet. For safety reasons, ONLY use the adapters included in the package.
2. Press and hold the POWER
3. The icon in the top right corner of the main screen will show you the battery power status.
4. The LED Ring on the front of the monitor also indicates the battery power status.
SOLID BLUE = BATTERY FULLY CHARGED
QUICK FLASHING BLUE = BATTERY LOW
EMPTY

Connecting Power to the Camera

1. Take the second power adapter and connect the small end of the power adapter marked
CAMERA into the DC input on the side of the camera base as shown in the diagram.
For safety reasons, ONLY use the adapters included in the package.
Note: Baby monitors and cameras with power cords should never be hung on or near the crib as it is a strangulation
hazard. Power cords should be kept no less than 3 feet away from the crib and the baby's reach at all times.
mylevana.com
button on the side of the monitor to turn the monitor ON.
SLOW FLASHING BLUE = BATTERY CHARGING
FLASHING PINK = PAIRING UNSUCCESSFUL
CHARGING FULL
into the DC input on the side of
12
Power
LED Ring
DC
Input
ON / OFF
Switch
DC Input