Getting Started; Attach Power To The Baby Unit Using The Ac Adapter; Installing Alkaline Batteries; Installing The Rechargeable Battery In The Parent Unit - Levana LV-TW200 Manuel D'utilisation

GETTING STARTED

Attach Power to the Baby Unit Using the AC adapter

1. Plug one end of the included power adapter into any available wall outlet.
2. Plug the small end of the power adapter into the DC jack on the back of the baby monitor.
Installing Batteries
1. Use a small flat head screwdriver to unlock the battery cover on the
back of the baby unit, taking care not to screw past the 'open' point.
2. Remove the cover and install 3 AA batteries.
3. Replace the battery cover and lock the compartment.

Installing the Rechargeable Battery in the Parent Unit

1. Use a small flat head screwdriver to unlock the battery
cover on the back of the baby unit, taking care not to
screw past the 'open' point.
2. Remove the cover and install the battery pack in the
compartment, ensure it fits into the corresponding
recess points. Follow the polarity instructions on the
diagram to the right.
3. Replace the battery cover and lock the compartment
4. Plug one end of the included power adapter into any available wall outlet.
5. Plug the small end of the power adapter into the DC jack on the back of the recharging
base, place the parent unit in the base to charge.

Switching the Units ON and OFF

1. Press the power button
indication LED's on the front of the unit will light up during start up.
2. Press the power button
up during start up.
3. The parent and baby units will automatically pair. If the units do not pair
automatically, see Pairing the Devices on page 15.
4. To power OFF the units, press and hold the power button
units until the LCD screen goes blank.
on the parent unit, the LCD screen and the sound
on the baby unit, the LCD screen and night light will light
10
on the parent and baby