Publicité
Step 12
Unfold the SMALL BACK (I2) and lay it over the bottom of your unit.
å
Diagram 1. Place the SMALL BACK (I2) into the edges of the LOWER ENDS (C2 and D2), with the bottom edge of the
å
SMALL BACK (I2) even with the bottom surface of the BOTTOM (F). There should be a gap between the top edge of
the SMALL BACK (I2) and the bottom edge of the LARGE BACK (H3).
Diagram 2. To fasten the bottom edge of the BACK (I2), place the off set edge of the Nail Holder down against the
å
BOTTOM (F). Place a NAIL into the nail slot of the Nail Holder. Tap the nail through the BACK and into the edge of
the BOTTOM (F). Remove the Nail Holder from the NAIL and completely tap the NAIL in with your hammer. Finish
fastening the BACK to the BOTTOM with the hammer and Nail Holder placing NAILS approximately 5-1/2" apart.
Diagram 3. To fasten the side edges, place the bead of the Nail Holder down between the SMALL BACK (I2) and the
å
LOWER LEFT END (D2) 1-1/2" from the corner. Place a NAIL (1N) into the nail slot of the Nail Holder. Tap the NAIL
through the BACK and into the lower edge of the LOWER LEFT END. Remove the Nail Holder from the NAIL and
completely tap the NAIL in with your hammer. Finish fastening the BACK to the LOWER LEFT END with the hammer
and Nail Holder placing NAILS approximately 5-1/2" apart. Repeat this process for the LOWER RIGHT END (C2).
Diagram 4. Fasten the remaining edges of the LARGE BACK (H3) and SMALL BACK (I2) to the SHELF (G3). Use three
å
BLACK 7/8" LARGE HEAD SCREWS (17S). Evenly space the screws as shown. The SCREWS will not go through the
BACKS, but they will fi t in the gap between the BACKS.
NOTE: There are no pre-drilled holes in the SHELF (G3). Use extra force when turning these screws.
å
17S
BLACK 7/8" LARGE HEAD SCREW
(3 used in this step)
NAIL
(22 used in this step)
2.
Off set edge
Nail Holder
C2
1N
F
These edges
must be even.
4.
I2
D2
Lower edge
1.
H3
G3
5-1/2"
Nail slot
Bead
1-1/2"
3.
Page 17
Publicité
