Sauder 410367 Mode D'emploi page 11

Step 6
Push four HIDDEN CAMS (1F) into the LOWER ENDS (C2 and D2). Then insert the metal end of a CAM DOWEL (2F) into
å
each HIDDEN CAM.
Slide the LOWER END MOLDINGS* (P) onto the notched edges of the LOWER ENDS (C2 and D2).
å
NOTE: The top edges of the ENDS and MOLDINGS should be even.
å
Fasten two ANGLE BRACKETS (5G) to the LOWER ENDS (C2 and D2). Use two BLACK 9/16" LARGE HEAD SCREWS (1S).
å
NOTE: Be sure the edges of the ANGLE BRACKETS are even with the long edges of the LOWER ENDS.
å
*U.S. Patent No. 5,499,886
å
Arrow
2F
Metal end
The large groove is
closer to this edge.
Do not tighten the HIDDEN CAMS in this step.
Top edge
1F
D2
The large groove is
closer to this edge.
C2
P
P
5G
5G
BLACK 9/16" LARGE HEAD SCREW
(2 used in this step)
1S
Page 11