Cooling Mode - OEG 650 001 127 Notice De Montage Et D'utilisation

62
4.4

Cooling mode

GB
IMPORTANT:
Before starting, make sure that the filtration pump is operating correctly.
Step 1: Press , to switch on your pump.
Step 2: Press to switch from one mode to another until the Cooling mode is dis-
played.
Step 3: Select the desired temperature (+8 up to +28 °C) by pressing
EXAMPLE:
If you have selected 24 °C, your screen will display:
Required
temperature
"Flashing"
Useful information about how the cooling mode works
IMPORTANT:
When the cooling mode switches to heating mode or vice-versa, the heat pump will
restart after 10 minutes.
When the water inlet temperature is higher or equal to the required temperature (set-
point temperature) +X °C, the heat pump will switch to cooling mode. The compressor
will stop when the water inlet temperature is lower or equals the required temperature
(setpoint temperature).
Indicators for adjustment range X and Y:
X: adjustable parameter from +2 °C up to +10 °C, default setting is at +3 °C.
Y: adjustable parameter from 0 °C up to +6 °C, default setting is at 0 °C.
Current water
temperature
Once the symbol
stops flashing,
the required tempe-
rature is validated
and replaced by the
new, current water
temperature (in our
example +27 °C).
Swimming pool heat pump
or .
Current ambient
air temperature