Water Treatment; Description; Scope Of Delivery; General Characteristics - OEG 650 001 127 Notice De Montage Et D'utilisation

The heat pump for swimming pools is compatible with all kinds of water treatment systems.
However, it is necessary that the treatment system (dosing pump for chlorine, pH, bromine
and/or salt chlorinator) is installed inside the hydraulic circuit downstream of the heating sy-
stem.
For optimal operation and a long service life, the pH value of the water should always
remain between 6.9 and 8.0.
• OEG heat pump
• Two hydraulic water inlet/outlet connections (ø 50 mm)
• Installation and user manual
• Condensation draining kit
• Protective cover for the winter
• 4 anti-vibration pads (fastening material not included in the scope of delivery)
The heat pump has the following characteristics:
• Certified heat pump complying with CE and RoHS directives.
• High energy efficiency with up to 80% energy savings compared to a conventional
heating system.
• Ecological and environment-friendly refrigerant R32 with high cooling capacity.
• Reliable and powerful compressor.
• Wide hydropholic aluminium evaporator for use at low temperatures.
• User-friendly, intuitive controller.
• ABS casing made of highly resistant material with UV resistant and easy-to-clean finish.
• Low-noise.
• Dual antifreeze system to prevent frost damage:
revolutionary heat exchanger with patented antifreeze system.
• Automatic monitoring system for frost protection.
Swimming pool heat pump
47

Water treatment

Description

Scope of delivery

General characteristics

GB
1.3
2
2.1
2.2