OEG 650 001 127 Notice De Montage Et D'utilisation page 55

55
Making a hydraulic connection with by-pass assembly
Hydraulic connection 3.6
IMPORTANT:
Do not run water through the hydraulic circuit for 2 hours after applying the adhesive.
Step 1: Take the necessary steps to cut your pipes.
Step 2: Make a straight, perpendicular cut through the PVC pipes with a saw.
Step 3: Chamfer the ends of the cut pipes with sandpaper
Step 4: Apply stripper to the ends of the pipes to be connected
Step 5: Apply the adhesive in the same place.
Step 6: Assemble the pipes by means of the by-pass connections.
Step 7: Make the hydraulic connection now.
Step 8: Remove any adhesive residues from the PVC.
GB
Swimming pool heat pump