Transtherm Caves PRESTIGE Serie Mode D'emploi page 14

6 - c
ommissioning your Wine cABinet
III-B. Temperature setting (3-temperatures model)
Maturing compartment recommended temperature setting range: 10 à 14 °C / 50 to 57 °F.
Red serving temperature compartment recommended temperature setting range: 16 à 20 °C / 61 to 68 °F.
The chilling compartment temperature is determined by the temperature set in the maturing compartment.
5 sec.
Press and hold down the key for 5 secs to power up.
1
Press and hold down the key for approximately 5 secs.
The display will start to flash.
3
Press the button to confirm.
The red serving temperature compartment temperature display
will flash.
II-C. Description (multi-temperatures model: Réserve)
A B C D E C
M L K J
A
Lighting mode
B
Open door alarm
C
Temperature zones concerned
D
Sensor fault alarm
E
Temperature alarm
F
Confirmation and setting access key
G
Setting and selection keys
12
GB
2
Press the or keys to set the desired temperature in
the maturing compartment.
4
Press the or keys to set the temperature of the red
serving temperature compartment.
5
Press the button to confirm.
The value shown on the display is the actual temperature inside
the cabinet. It is therefore necessary to wait before your new
setting takes effect.
•
For the maturing compartment, the default setting is 12°C / 54°F (ideal
maturing temperature). However you can set the temperature between
9 - 15°C / 48 - 59°F.
•
For the red serving temperature compartment, the default setting is
18°C / 64°F (ideal temperature for bringing red wine to the correct
serving temperature). However you can set the temperature between
15 - 20°C / 59 - 68°F.
N.B: in order to operate correctly, your cabinet must be placed in a room
with a temperature of 12 - 30°C / 54 - 86°F.
F G H
The tactile keys are very sensitive.
There is no need to apply force, a light
touch is sufficient to register the
command. Remember to remove your
finger from the panel between presses.
I
H
Lighting mode access and confirmation key
I
Power button
J
Display of the temperature on the top of the cabinet
K
Hot circuit in-use indicator
L
Cold circuit in-use indicator
M
Display of the temperature on the bottom
of the cabinet
6 - c
ommissioning your Wine cABinet
III-C. Temperature setting (multi-temperatures model)
Recommended temperature setting range for the lowest temperature: 7 - 9 °C / 45°F - 48°F.
Recommended temperature setting range for the highest temperature: 17 - 20 °C / 63°F - 68°F.
5 sec.
Press and hold down the key for 5 secs to power up.
1
Press and hold down the key for approximately 5 secs.
The display will start to flash.
3
Press the button to confirm.
The right-hand display will flash.
The value shown on the display is the actual temperature inside
the cabinet. It is therefore necessary to wait before your new
setting takes effect.
IV. Setting the lighting mode (all models)
1
Press the key approximately 5 seconds.
The indicator of the active mode will flash
There are 3 setting options for lighting:
Permanent lighting (mood lighting for a cabinet fitted with a glass
door, for example).
Lighting which comes on when the door opens (it is switched off
when the cabinet door is closed).
Lighting disabled
2
Press the or keys to set the desired temperature.
4
Press the or keys to set the desired temperature.
5
Press the button to confirm.
•
For the lowest temperature, the default setting is 8°C / 46°F. However
you can set the temperature between 6 - 10°C / 43 - 50°F.
•
For the highest temperature, the default setting is 18 °C / 64°F.
•
However you can set the temperature between 15 - 20 °C / 59 - 68°F.
N.B: in order to operate correctly, your cabinet must be
placed in a room with a temperature of 12 - 30 °C / 54 - 86°F.
2
Press the or keys to select the desired mode.
3
Press the key to confirm
Precaution : bright light, never look directly at the LED beam.
13
GB