LaserLiner DampFinder Home Mode D'emploi page 10

4
To change measuring mode
1x
1 sec
!
The device starts with the measuring mode last selected.
5
Self-test function
Measurement procedure notice
Be sure neither supply lines (electric lines, water pipes, etc) nor
a metal subsurface is present at the location to be measured.
Insert the electrodes as far into the material as possible but
never use excessive or sudden impact force as this could
!
damage the unit. Always pull the unit out of the material
with left/right twisting motion. Perform several comparative
measurements at different locations to minimise measure-
ment error. The sharply pointed electrodes present an injury
hazard. Always put the safety cap on the unit when it is not in
use or being transported.
10
EN
Device on
1x
1 sec
1.
1.
1x 1x
1 sec 1 sec
2.
2.
1x 1x
1 sec 1 sec