Transport; Storage; Disposal And Recycling - Scheppach GP1000 Jet LCD Traduction Des Instructions D'origine

• If there is a risk of frost the pump must be completely
emptied.
• After longer periods of storage check the pump by
switching on/off briefly in order to check that the ro-
tor turns normally.
• In the event of the pump being jammed connect the
pressure line to the water supply line and remove
the suction hose. Open the water supply line. Switch
the pump on for ca. two seconds several times. This
method rectifies blockages in most cases.
• To clean the pre-filter (12) unscrew the pre-filter cap
(11) and remove it. Afterwards, clean it with clear
water.
Connections and repairs
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the
event of any enquiries:
• Type of current for the motor
• Data of machine type plate
• Data of motor type plate
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*:Seals, pre-filter
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.

13. Transport

Always use the transport handle (2) for transporting the
product.

14. Storage

Store the product and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 ˚C.
Store the product in its original packaging.
Cover the product to protect it from dust or moisture.
Store the operating manual with the product.

15. Disposal and recycling

The device is supplied in packaging to avoid
transport damages. This packaging is raw ma-
terial and can thus be used again or can be
reintegrated into the raw material cycle.
The device and its accessories are made of
different materials, such as metals and plas-
tics. Take defective components to special waste dis-
posal sites. Check with your specialist dealer or munic-
ipal administration!
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point. This can
be done, for example, by returning it when purchasing
a similar product or delivering it to an authorised collec-
tion point for the recycling of old electrical and electron-
ic devices. Improper handling of waste equipment may
have negative consequences for the environment and
human health due to potentially hazardous substances
that are often contained in electrical and electronic
equipment. By properly disposing of this product, you
are also contributing to the effective use of natural re-
sources. You can obtain information on collection
points for waste equipment from your municipal admin-
istration, public waste disposal authority, an authorised
body for the disposal of waste electrical and electronic
equipment or your waste disposal company.
www.scheppach.com GB | 27