AVM FRITZ!DECT 100 Mode D'emploi page 6

Each DECT repeater is registered with
the base station. It is not possible to
connect multiple repeaters with each
other directly.
Registering a repeater does not re-
duce the number of telephones you
can register with your base station.
Buttons and LEDs
FRITZ!DECT Repeater 100 has 2 buttons
with LEDs.
Button Function
Status
> Switch on/off LEDs.
DECT
> Deregister from the base
station: Press for at least
6 seconds.
> Register with the base station.
Hold the button down, until the
button fl ashes. Within
2 minutes, start the registration
of a new device with the base
station. For more information,
see page 7.
10
LED Condition Meaning
Status disabled > The LEDs are switched off .
on > At least one registered cordless telephone has estab-
lished a connection.
fl ashing regularly > Transmitting fi rmware update to FRITZ!DECT Repeater
100.
DECT
disabled > The LEDs are switched off .
on > FRITZ!DECT Repeater 100 is connected with the base
station.
fl ashing regularly > Registering with the base station.
short fl ash / long > No connection with the base station.
pause
FRITZ!DECT Repeater 100 is either not registered or
outside the range of the base station.
11