AVM FRITZ!DECT 100 Mode D'emploi page 4

Requirements
To operate your FRITZ!DECT Repeater 100
you need:
 230-volt outlet
 FRITZ!Box with an integrated DECT
base station or
DECT base station from another
manufacturer, with which it is possible
to register a repeater compliant with
the DECT-GAP standard.
 For registration of FRITZ!DECT Repeater
100 the DECT PIN 0000 must be
preset in the base station.
In a FRITZ!Box the DECT PIN is set in the
http://fritz.box.
user interface
Socket
FRITZ!DECT Repeater 100 has what is
called a "looped through" socket. If the
repeater is connected to the power mains,
its socket will supply power.
This means that the wall outlet used by
FRITZ!DECT Repeater 100 can be used by
other devices.
The repeater's socket has a maximum
load limit of 2300 W / 10 A.
Status Status
DECT DECT
6
Registering with FRITZ!Box
Register FRITZ!DECT Repeater 100 with your
FRITZ!Box or another DECT base station.
1. Insert FRITZ!DECT Repeater 100 in an
outlet near the base station.
The "DECT" LED begins fl ashing in an
even rhythm.
2. Within 2 minutes, start the registration
of a new device with the base station.
Proceed just as you did to register a
cordless telephone. For more informati-
on, see the manual of the base station.
If you are registering with a FRITZ!Box,
press the "DECT" button until the "Info"
or "DECT" LED on the FRITZ!Box begins
fl ashing.
WLAN W LAN W N
DE D ECT DECT D ECT D DECT DE D E CT E CT
W W W W L W WLAN L AN
10 seconds
7