Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
NAMES AND FUNCTIONS OF INDICATIONS ON WIRELESS
REMOTE CONTROLLER
Display
All indications, except for clock time indication, are indicated by pushing the START/STOP button.
1 Transmission mark
1
1
1
1
This transmission mark (,) indicates when the remote controller transmits signals to the indoor unit.
2
2
2 Mode display
2
2
Indicates the current operation mode.
(AUTO : Automatic control, A : Auto changeover control,
: Dry,
: Heat,
3
3 Temperature display
3
3
3
Indicates the temperature setting (17°C to 30°C).
When you set the operating mode to
setting is indicated.
4
4
4
4 FAN speed display
4
Indicates the selected fan speed. AUTO or one of five fan speed levels
+
(LOW
, LOW
HIGH
Indicates AUTO when the operating mode is either AUTO or
5
5
5 TIMER and clock time display
5
5
The time set for timer operation or clock time is indicated.
The present time is always indicated except for TIMER operation.
6 Hi POWER display
6
6
6
6
Indicates when the Hi POWER operation starts.
Push the Hi POWER button to start and push it again to stop the
operation.
7 ECO display
7
7
7
7
Indicates when the ECO (save energy) operation starts.
Push the ECO (save energy) button to start and push it again to
stop the operation.
8
8
8
8
8
(PRESET) display
Push another button to turn off the mark.
9
9 SLEEP TIMER display
9
9
9
Indicates when the SLEEP TIMER is in operation.
Each time you push the SLEEP button, the display changes in the sequence of 1, 3, 5 or 9h.
PREPARATION AND CHECK BEFORE USE
Loading the remote controller batteries.
1
1 Remove the cover, and insert the
1
1
1
batteries.
2 Push the RESET button.
2
2
2
2
The clock display flashes.
Adjust the clock.
Place back the cover.
Batteries
• To replace the batteries, use two new batteries (AAA type).
• In normal use, the batteries will last about one year.
• Replace the batteries if there is no receiving beep from the
indoor unit or when the air conditioner cannot be operated using
the remote controller.
• To avoid malfunctions by battery leakage, remove the batteries
when not using the remote controller for more than one month.
EN
: Fan only)
: Fan only, no temperature
, MED
, MED
) can be indicated.
: Cool,
+
,
: Dry.
• Slide off the cover while
pressing the sides.
• Battery replacement
Be careful not to reverse the
(+) position and the (–)
position.
5
3 1
2
6
7
• In the illustration, all indications
are indicated for explanation.
During operation, only the
relevant indications will be
indicated on the remote controller.
9
2
8
4
5
1
Publicité
Table des Matières
