Urmet IPercom 1741 Notice D'installation page 9

5. DEVICE CONFIGURATION
Refer to the technical system manual by scanning the following QR Code with the camera of your smartphone
or tablet to configure the device.
6. TECHNICAL SPECIFICATIONS
POE input voltage: ......................................................................................................................... 48-54 V
Max consumption: ................................................................................................................................... 10 W
S+, S- terminal outputs: ......................................................................................................... 25 mA @ 24V
Display: ................................................................................................................................................. 7" TFT
Touchscreen: ................................................................................................................................. Capacitive
Resolution: ............................................................................................................................... 1024 x 600 px
Brightness: ...................................................................................................................................... 350 cd/m
Viewing Angle (H/V): ...................................................................................................................... 106° / 160°
Operating Temperature: ...................................................................................................................-5 ÷ 45°C
Max number of video door phones on the POE ports of switch 1039/44: .................................................... 2
Dimensions (WxHxD): .................................................................................................... 200 x 130 x 24,5 mm
15.105 Information to the user statements:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
DS1741-001
2
9