Fiamma Privacy R 300 Instructions De Montage Et Mode D'emploi page 20

DE Gebrauchsanweisungen und Ratschläge
FR
Instructions et conseils
IT Avvertenze e suggerimenti
2. Additional information for the consumer
Fiamma Privacy-Rooms are made with accuracy, but some characteristics of the
materials, which could be interpreted as defects, derive from the materials and from the
specific work processes, and these characteristics would occur even though Fiamma
used advanced and innovative machines and production techniques.
The following characteristics are not grounds for reclamation:
Irregularities in the texture (e.g. knots and densities) are due to inevitable endurance in the
manufacture process and there is no reason to get alarmed; they do not affect the quality of
your Fiamma Privacy-Room in any way.
The formation of condensated water in the interior of the awning is a phenomenon which
derives from the variations between the external and internal temperature. Due to this
difference in temperature, the humidity raises and settles on the internal part of the ceiling.
With a watertight floor and a good ventilation, the condensated water can be notably
reduced.
The zips are products subject to the wear and tear so it's important to open and close them
gently and slowly (without pulling). It is recommended to avoid using excessive strain, fixing
them to the ground. To ensure a smooth opening and closing and to avoid that the zip gets
stuck, we advice you to clean the zips regularly with a proper spray.
To guarantee a perfect quality, the fabrics are waxed or laminated several times. During
this operation, single coloured pigments could move creating small bright spots in the
material, which are only irregularities, technically inevitable, but they do not influence the
impermeability of the fabric. The awning and the walls are therefore completely hermetic,
also in these spots.
During the production of the materials, small creases could form, especially on bright fabric,
that in backlight could seem dark. Bright stripes (also called white crease) are unavoidable
with these materials.
Eventually the influence of weather could cause changes of colour.
Accessories to tie, e.g. hooks and eyelets, as well as straps against the wind are subject to
wear. Their lifetime depends on the use of the product.
20
EN
ES
Fiammastore
Maintenance instructions
Recomendaciones