Batteries Installation - claber Dual Select Mode D'emploi

Batteries installation

US
The timer requires 2 AA 1.5V (LR6) alkaline batteries, which normally will
be sufficient for an entire dry season (assuming an average of 3 watering
cycles per day).
To install or replace the batteries, proceed as follows (fig.2):
• Firmly press the tab located at the bottom of the timer (
the same time pull back (
• Remove dead batteries, if in place.
• Fit the new batteries in the holder, observing the correct polarity
➌
( ).
• Refit the front part of the timer to the back from top to bottom, mak-
ing sure that the locking tab clicks into place.
2
1
fig.2
6
➋
).
2
➊
) and at
3
1,5 V
AA
Alkaline