Replacing The Gel Film; Disposal; Technical Specifications - Beurer EM 25 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
Important note!
• Switch off the glute toning device before removing it.
• Replace the batteries if they are low.
• The device will only work if there is sufficient contact
with the skin. If the device is not pressed on there will
be no stimulation.
• Do not use the glute toning device more than once per
day.
• In the event of continuous beeping, shut down the
device. Clean the gel film and try to restart the program.
If the continuous beeping persists, replace the gel film.
• If the adhesive capability of the gel film decreases,
replace immediately. Do not use the glute toning device
again until the gel film has been replaced. Otherwise
the unequal distribution of the gel film could lead to skin
lesions.
• In the event of unpleasant current peaks, switch off the
glute toning device and clean the gel film.

4. Replacing the gel film

1. Fully remove the old, used gel film [5].
2. Carefully remove the blue protective
film [3].
3. Carefully attach the gel film to the glute
toning device and detach the protective
film. Ensure that the edge of the gel film does not
protrude over the glute toning device [4].
WARNING!
Make sure that you attach the gel film to the device on
the side where the blue protective film was, otherwise the
skin could become irritated.

5. Disposal

The empty, completely flat batteries should be dispo-
sed of through specially designated collection boxes,
recycling points or electronics retailers. You are legally
required to dispose of the batteries.
Note: The codes below are printed on batteries
containing harmful substances:
Pb = Battery contains lead, Cd = Battery contains
cadmium, Hg = Battery contains mercury.
Please dispose of the device in accordance with
EC Directive – WEEE (Waste Electrical and Electro-
nic Equipment). If you have any questions, please
contact the local authorities responsible for waste
disposal.
5

6. Technical specifications

Type
Output wave
form
Pulse length 400 μs
Pulse
frequency
Output
voltage
16
EM 25 glute toning device
Biphasic rectangular pulse
4-50 Hz
max. 90 vpp (1000 ohm)

Publicité

Table des Matières
loading

Table des Matières