Cleaning And Storage; Troubleshooting - MAXXMEE JCC001 Mode D'emploi

EN

CLEANING AND STORAGE

Please Note!
■
During cleaning make sure that no liq-
uid gets into the main unit (apart from
the water tank) or the handle.
■
Do not use any sharp or abrasive
cleaning agents to clean the housing.
They may damage the surfaces.
 
The mop pads may lose some
of their colour over time. This
is normal and does not have
any adverse effect on function.
However, if one of the mop pads
is damaged or worn, it must be
replaced.
• If there is still water in the water
tank (11), empty it by pressing the
spray button (1). This is necessary to
avoid any calcifi cation of the device
and the spray nozzle (10).
• Remove the insert (I) from the buck-
et (H) and empty the bucket (Picture F).
• Clean the bucket and insert with warm
water and a little detergent.
• Clean the device with a damp, soft
cloth if necessary. Then dry with a soft
cloth.
• Pull the mop pads (E) off the clean-
ing feet (9) and clean them. Note the
washing label when you do this! Please
Note: Wash separately or with similar
colours. Do not use fabric softener.
• Charge up the battery after every use
(see the "Charging Up the Battery"
chapter).
• Store the device and the accessories
in a dry place which is protected from
sunlight and is out of the reach of
children and animals.
18

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps listed, contact
the customer service department.
Do not attempt to repair an
electrical device yourself!
The battery is not charging. The LED
display (6) does not fl ash when the
device is connected to the mains
power.
The mains adapter (A) is not inserted in
the plug socket correctly.
► Correct the fit of the mains adapter.
The barrel connector is not plugged in
the charging socket (5) of the device
correctly.
► Correct the connection between the
charging socket and barrel connector.
The plug socket is defective.
► Try another plug socket.
There is no mains voltage.
► Check the fuse of the electrical dis-
tributor (fuse box).
The device cannot be started.
The battery of the device is too weak.
► Charge up the battery.
The release mechanism in the stem
mount (4) has been triggered.
► Activate the device by tilting the stem
or the stem mount backwards.
The device is not working correctly.
The fl oor is unsuitable for the device.
► The device only works on smooth
floors such as parquet, laminate, tiles
etc.