Before Initial Use; Assembling The Device - MAXXMEE JCC001 Mode D'emploi

Balai rotatif rechargeable
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Cordless Rotary Mop
Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and
to avoid possible damage.
NOTICE – Risk of Damage to
Material and Property from Batteries
Remove the battery from the handle
when it is used up. This will prevent
any damage caused by leaks.
Use only the battery type specifi ed in
the technical data. Pay attention to
the correct polarity (+ / –) when replac-
ing batteries.
Non-rechargeable batteries must not
be recharged or reactivated by other
means, dismantled, thrown into a fi re,
immersed in fl uids, or short-circuited.

BEFORE INITIAL USE

Assemble the device (see the "As-
sembling the Device" chapter).
Charge up the battery (see the
"Charging Up the Battery" chapter).

ASSEMBLING THE DEVICE

PLEASE NOTE: Tilt the stem mount (4) on
the main unit (B) forwards until it engages.
It must be upright so that the device is
deactivated and cannot be switched on
accidentally. The LED display (6) must
have gone out.
1. Plug the stem parts (G) into each
other as follows. They must lock into
each other.
2. Plug the handle (F) into the top of the
stem. It must engage audibly.
3. Plug the stem with the handle into the
stem mount on the main unit. It must
engage audibly.
To detach the stem, the handle or take
the stem apart, the removal tool (D) is re-
quired. Plug it in each case into the small
opening on the stem parts and pull out
the top part at the same time.
Attaching / Detaching Mop Pads
Please Note!
The mop pads must not be attached
to the cleaning feet when they are wet.
Attaching: Attach one mop pad (E) in
each case to a cleaning foot (9) using
the hook and loop fastener.
Detaching: Pull the mop pads off the
cleaning feet.
Folding the Carrying Handle of the
Bucket In / Out
Folding out: Flip up the carrying
handle and pull it up into the vertical
position to fi x it in place.
Folding in: Push down the carrying
handle and fold it down (Picture C).
EN
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

01017

Table des Matières