Use - MAXXMEE JCC001 Mode D'emploi

Cordless Rotary Mop
Filling the Bucket
Please Note!
■
Note the maximum fi ll level of the
bucket. If the bucket is overfi lled,
there is the risk that water will get into
the main unit when the mop pads are
cleaned.
1. Remove the insert (I) from the buck-
et (H).
2. Fill the bucket with water. IMPORTANT!
It is essential to note the MIN and MAX
markings in the bucket.
3. Place the insert back into the bucket.
 
The water must not cover the
insert once it has been inserted.

USE

 
Switch off the device after you
fi nish cleaning each surface so
that the operating time on each
battery charge is increased signif-
icantly.
1. Tilt the stem mount (4) on the main
unit (B) back a little using the han-
dle (F) in order to trigger the release
mechanism and activate the device.
It is in stand-by mode. The LED dis-
play (6) lights up blue.
2. Press the On / Off button (2) on the
handle to switch on the device. The
two cleaning feet (9) start to rotate.
3. Guide the device over the surface to
be cleaned or polished.
4. If necessary, press the spray button (1)
on the handle to add extra moisture
to the fl oor with the aid of the spray
nozzle (10).
5. To switch off the device, press the
On / Off button again. The cleaning
feet stop rotating.
6. Tilt the stem mount on the main unit
forwards using the handle in order to
trigger the release mechanism and
deactivate the device. You must feel
the stem engage. The LED display
goes out.
Wetting / Cleaning Mop Pads
To achieve an optimum mopping result,
the mop pads (E) can easily be wetted
and cleaned during use.
1. Tilt the stem mount (4) on the main
unit (B) forwards until it engages. It
must be upright so that the device is
deactivated and cannot be switched
on accidentally. The LED display (6)
must have gone out.
2. Place the main unit on the insert (I) in
the water-fi lled bucket (H) (Picture E).
When you do this, make sure that the
recesses of the cleaning feet (9) fi t
on the corresponding bulges of the
insert.
3. Hold the mop securely – do NOT
press down – and press the cleaning
button (3).
The LED display lights up blue.
The cleaning feet rotate inwards for
approx. 10 seconds. The rollers rotate
and the mop pads are wetted and
cleaned. The cleaning feet then rotate
outwards for approx. 20 seconds. The
rollers stop and the excess water is
removed from the mop pads.
When the LED display goes out., the
process is complete.
4. Continue cleaning the fl oor.
 
For heavier soiling and resilient
fl oors, the mop pads can be wet-
ted without wringing them out. To
do this, place the main unit in the
bucket, tilt the stem backwards
to activate the device, and press
the On / Off button (2). Once the
mop pads have been suffi ciently
moistened, press the On / Off
button again.
EN
17