Troubleshooting; Care And Maintenance; Disposal - HYDROMETER GPRS Receiver Battery Mode D'emploi

Troubleshooting

Should the GPRS Receiver Battery not work as described in this document, please
check the list of possible error causes below for a solution:
x While connecting the GPRS Receiver Battery to a PC, the operating system
shows a warning message of an unknown USB device.
o Disconnect the USB cable, wait 5 seconds and connect the cable again.
o If the error remains, repeat the above measure and connect the GPRS
Receiver Battery to another USB connector of your PC or, if possible, to
another PC or notebook.
o Disconnect the USB cable to the GPRS Receiver Battery and restart
your PC.
o Use a different USB cable.
o If the USB driver of the GPRS Receiver Battery is not correctly installed
on your PC system (e.g. because you have interrupted the driver
installation the first time), you have to de-install the GPRS Receiver
Battery from the device manager of Windows (search under COM and
LPT or USB while the GPRS Receiver Battery is connected).
Afterwards, disconnect the GPRS Receiver Battery, wait 5 seconds and
reconnect it again. The device installation wizard should show up and
you should now install the GPRS Receiver Battery USB driver correctly.

Care and Maintenance

x Clean the GPRS Receiver Battery only if the case is closed (water tight).
x Clean the device only with a soft cloth, moistened with mild soapy water.
x Never use strong detergents or hard brushes.
x Disconnect the battery pack if you plan to not use the GPRS Receiver Battery
for a longer period of time.

Disposal

The GPRS Receiver Battery must not be disposed together with the domestic waste.
All users are obliged to hand in all electrical or electronic devices, regardless of
whether or not they contain toxic substances, to ensure a disposal in environmentally
acceptable manner.
Therefore, return the device at the end of its lifetime to the manufacturer (address on
page 2).
16 GPRS Receiver Battery