Publicité
Les langues disponibles
Les langues disponibles
3. When holding either end of the crossbrace assembly, turn the barrels so plunger knobs
are on top (Detail "A").
NOTE: Ensure the long end of the barrel faces the center of the bed with the decal to the center of
bed as shown in FIGURE 1 on page 4. If long end faces the opposite way, rotate crossbrace 180°.
4. Position the bed hooks so they are on the bottom side of the crossbrace (Detail "B").
5. Perform one of the following:
• Standard Hardware Installation ‐ Perform the following steps:
i. Attach one bed hook onto the bed spring angle iron and push in on the spring
loaded bed rail until you are able to attach the opposite end to the bed spring
angle iron (Detail "B").
ii. Rotate the barrel so that the long ends face down (Detail "B").
NOTE: Ensure plunger pins are facing the center of the bed.
• Optional Hardware Installation ‐ Perform the following steps:
i. Attach wingnuts to bed hooks.
ii. Tighten until the wingnut reaches the bed spring angle iron.
iii. Rotate the barrel so that the long ends face down.
6. Visually inspect crossbrace to confirm proper orientation.
7. Position the remaining crossbrace between the second and third springs at the foot end
of the bed.
NOTE: If the bed frame contains BLACK springs at the second and third spring locations at the
foot end of the bed, position the crossbrace between these springs.
8. Repeat STEPS 3‐7 for the foot end crossbrace.
9. Place mattress on bed frame.
10. Install the bed rails. Refer to Installing the Bed Rails on page 4.
Part No 00077x079
3
Reduced Gap Deluxe Full-Length Bed Rail
Publicité
