Solera Eco D-112 Manuel Pour L'emploi Et L'entretien page 24

Warning: If, when the
electronic board is in Slush
Mode, the product
temperature is greater than
5°C, the following screen will
be displayed:
Auto / Setting / Wait
*
X
This screen indicates that the
calibration process is taking
place. The calibration process
will take one minute to
complete.
If you press the button
(Cooling off- cold drink-
slush) you can switch the
machine functioning modes
alternatively. Each time you
press the button, the different
screens of cold drink – slush
and cooling off alternate. In this
latter position only the augers
rotate and no other action is
taken.
If you press the auger rotation
key , the display will
appear as follows:
StandBy
Press
By holding the
for one second you will enter
the selection menu.
Please note that unless you
give any further instruction to
the electronic board in more 10
seconds time, the display will
automatically go back to the
initial screen.
LAMP
OFF / ON
This screen allows you to turn
ON or OFF the light in the lid,
by pressing the and
buttons of the electronic board.
ByPass
OFF / ON
In this screen you can activate
or deactivate the bypass
function by pressing the
increase
keys.
LowLevel
OFF / ON
This screen allows you to turn
ON or OFF the Low Level
control function (automatic
decrease of slush's density to
no.1, when the level probe is
not covered with product for
more than 20 minutes); you can
do that by pressing the
increase
decrease
some product (liquid that
touches the level probe), the
function will be deactivated and
the slush preparation will reach
the density value that was
previously set on the electronic
board. When this function is
active, you will see the
following display:
Please/refill/
*
button
As for the selection menu, the
next screen is like the one
below:
KeyBoard
UNLOCK / LOCK
and decrease
key or the
key. If you add
LOWLEVEL
1L
- 23 -
This screen allows you to
activate (LOCK) or deactivate
(UNLOCK) the "keyboard lock"
function by pressing the
buttons. This function is
suitable in self-service places,
in order to avoid people from
changing the values set. When
the keyboard is locked, the
electronic board will show a
"dot" on the display as shown
on the screen below:
SLUSH
*
X
■
If the machine is turned OFF
and ON, the electronic board
will be in LOCK position again.
Warning: The keyboard lock
can be activated if the
electronic board is in
"Standby" or "MotorOn"
mode.
Washing
OFF / ON
Turning OFF and ON of the
washing function. If the function
is active, the electronic board
will show the screen below:
Washing
■
in this condition all buttons and
the cooling functions are NOT
active, a pat from the MENU
button.
TIME
hh:mm
This screen shows the time set
on the machine. If it is different
from the place where the
machine is installed, you can
change it by following the steps
below:
or