iRobot Roomba j7 Guide Du Propriétaire page 11

Cleaning the Front Caster Wheel
1
Pull firmly on the front wheel module to
remove it from the robot.
EN
2 Pull firmly on the wheel to remove it
from its housing (see illustration below).
3
Remove any debris from inside the
wheel cavity.
4 Reinstall all parts when finished.
Make sure the wheel clicks back into
place.
Housing
Important:
A front wheel clogged with
hair and debris could result in damage to
your floor. If the wheel is not spinning freely
after you have cleaned it, please contact
Customer Care.
6
For more information, visit global.irobot.com
Washing the Bin
Important:
Remove the filter before washing the bin.
Release the bin, remove the filter,
1
and open the bin door.
2
Rinse the bin using warm water.
Axle Wheel
Note:
Make sure bin is completely dry. Reinsert
3
filter and place bin back in the robot.
Do not wash the filter.
Bin is not dishwasher safe.
Cleaning the Edge-Sweeping Brush
Use a coin or small screwdriver to
1
remove the screw holding the Edge-
Sweeping Brush in place.
Pull to remove the Edge-Sweeping
2
Brush. Remove any hair or debris, then
reinstall the brush.