Important; Installation Specifications; Installation Planning - Dacor Renaissance RNWO127 Instructions D'installation

Masquer les pouces Voir aussi pour Renaissance RNWO127:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation Planning

WARNING
Observe all governing codes and ordinances during plan-
ning and installation. Contact your local building depart-
ment for further information.

IMPORTANT

• Locate the junction box so that the oven may be easily
disconnected in the event that it needs to be removed
from the wall completely for service.
• If the oven is not installed level it may deliver poor or
inconsistent baking results.
Carefully check the location where the oven is to be
installed. The oven should be placed for convenient
access. Make certain that electrical power, meeting the
specifications on page 4, can be provided in the
selected location.
Dacor recommends installing the junction box in the
one of the locations shown on the facing page.
Cabinet Dimensions
Model
Number
RNWO(V)127
RNWO(V)130
RNWO(V)227
RNWO(V)230
6

Installation Specifications

Cabinet tolerances: +1/16 (1.6 mm), -0, unless otherwise stated.
(N) Minimum
Cabinet Width
27" (68.6 cm)
30" (76.2 cm)
27" (68.6 cm)
30" (76.2 cm)
Minimum interior cabinet depth: 24" (61.0 cm)
Install the junction box in a location that allows the
oven to be removed from the cutout for service without
being disconnected.
Plan the installation so that all minimum clearances are
met or exceeded. Dimensions shown provide minimum
clearances, unless otherwise noted. Be certain that
proper clearance is provided for the oven door when
it is in the open position according to the Product
Dimensions.
Cabinet cutout dimensions must be used as indicated.
The specified minimum cabinet depth and width must
be provided. The cabinet depth and width must com-
pletely enclose the recessed portion of the oven.
All contact surfaces between the appliance and the
cabinet must be solid and level.
Provide a platform within the cabinet to support the
oven. It must be installed level and straight. The top
edge of the platform must be flush with the cutout at
the front of the cabinet. There are no provisions to level
the oven after it has been installed. 3/4" (1.9 cm) thick
plywood is recommended.
(P) Cutout Width
25 5/8" (65.1 cm)
minimum (recommended)
26 1/8" (66.4 cm)
maximum
28 5/8" (72.7 cm)
minimum (recommended)
29 1/8" (74.0 cm)
maximum
25 5/8" (65.1 cm)
minimum (recommended)
26 1/8" (66.4 cm)
maximum
28 5/8" (72.7 cm)
minimum (recommended)
29 1/8" (74.0 cm)
maximum
(R) Minimum
Cutout Height
27 1/2"
(69.9 cm)
49 7/8"
(126.7 cm)

Publicité

Chapitres

Table des Matières
loading

Table des Matières