Heath Zenith 4190 Serie Mode D'emploi page 3

WIRING
Note: All wiring should be run in accordance
with the National Electrical Code through
conduit or another acceptable means.
Contact a qualified electrician if there is
any question as to the suitability of the
system.
CAUTION: DO NOT connect the RED
wire unless you want to control other
lights from the motion sensor.
Black
Green
or Bare
White
One Motion Light
White
Black
Green
or Bare
Two Motion Lights
204031-02
Light
Fixture
Light Light
Fixture Fixture
❒ Twist the junction box wires and the
fixture wires together as shown below.
Secure with wire connectors. If you have
a metal junction box, you may not need
the green "pigtail".If you are unsure about
the grounding method, consult your local
building code.
Connect the fixture wires to the wires in the
junction box. Twist the wires together and
secure with wire connectors.
Recommended Grounding Method
Use a green ground "pigtail" (not provided) and
twist one end together with the bare fixture wire
and the box ground wire. Secure with a wire
connector. Secure the other end of the "pigtail"
with the GND screw on the X-bar.
Black to black
3
White to white