Lutron LUT-LBX-CE Instructions D'installation page 2

Les langues disponibles

4.5 in. (115 mm)

I I n n t t e e r r f f a a c c e e s s h h o o w w n n w w i i t t h h f f a a c c e e p p l l a a t t e e r r e e m m o o v v e e d d

This "load-side" equipment installs on the zone wiring in

parallel with the lighting load. It provides an equivalent

minimum load for Lutron dimmers when the actual load

is too low for proper control unit operation.

Input:

•220 - 240 V

65 mA 50 / 60 Hz (LUT-LBX-CE)

•Power dissipation less than 10 watts

Typical 240 V~ LUT-LBX-CE Power

4.5 in. (115 mm)

Dim m ing Angle %

D D a a n n g g e e r r ! ! Always turn OFF the circuit breakers/MCB or

remove the main fuses from the power line before

doing any work. Failure to do so can result in serious

personal injury. D D i i s s c c o o n n n n e e c c t t a a l l l l p p o o w w e e r r s s o o u u r r c c e e s s b b e e f f o o r r e e

s s e e r r v v i i c c i i n n g g u u n n i i t t . .

1 1 . . This Interface must be installed by a qualified electri-

cian in accordance with all applicable regulations.

2 2 . . Improper wiring can result in personal injury, damage

to the Interface, or damage to other equipment.

3 3 . . One L L U U T T - - L L B B X X - - C C E E per circuit below minimum load.

4 4 . . The L L U U T T - - L L B B X X - - C C E E must be mounted with arrows on

yoke facing upward to ensure adequate cooling.

5 5 . . C C A A U U T T I I O O N N ! ! Dimmed magnetic low-voltage transform-

ers: To avoid excessively high current flow that can

cause transformer overheating and failure, observe the

following:

(a) Do not operate the MLV dimmers with all of the

lamps removed or with any lamps inoperative.

(b) Replace any burned out lamps immediately.

tection or fused primary windings.

6 6 . . The LUT-LBX-CE does not change the approved load

types of the dimmer. Use the required dimmer for the

given load type.

7 7 . . For LED lighting dimming operation, refer to Application

Note #138.

2 2