Skil MS6305-00 Guide D'utilisation page 22

Installing the dust bag
1. Squeeze the clamp ears of the dust bag
and push the clamp until it is completely
snapped into the neck of the dust port.
Then release the clamp ears. To ensure the
dust bag is securely positioned, pull the
dust bag to verify. (Fig.11).
2. Position dust bag so that it does not
interfere with the tool during the cutting
operation for all miter/bevel settings.
NOTICE: The dust bag requires emptying
when it is full of sawdust. Empty it frequently
and after the completion of sawing.
WARNING
in fine particle form may be explosive. Do not throw sawdust on an open fire. Spontaneous
combustion may, in time, result from mixture of oil or water with dust particles.
3. A standard 1-1/4" vacuum
Removal and installation of the
insert plate (Fig .12)
WARNING
the insert plate is not adjusted properly, the
workpiece can catch on the uneven edges,
resulting in binding, which could result in
serious personal injury.
WARNING
installed .
The plastic insert plate is not a
universal part among miter saws. If the insert
plate is worn, ask an Authorized SKIL Service
Center or Service Station for a replacement
part to help to ensure personal safety.
To remove/replace the insert plate:
1. Unplug the saw.
2. Remove the screws securing the insert plate with the supplied
Wrench.
3. Lift the insert plate from the saw.
4. To reinstall the insert plate, align the holes in the insert plate with the holes in the saw
base.
5. Retighten the screws, being careful not to overtighten which can cause the insert plate to
bow or bend.
22
Be extremely careful with
disposed dust; materials
tube can also be attached to the dust port for dust collection.
The insert plate must sit
below the miter table . If
Never operate the saw
without an insert plate
Fig. 11
2
Fig. 12
Double-Ended Allen
Dust Port