Skil MS6305-00 Guide D'utilisation page 18

WARNING
Installation of the carrying handle
(Fig . 2)
1. Place the carry handle onto main handle
and use the counter bores to align the two
mounting holes.
2. Insert the two screws provided into the
mounting holes in the carry handle and use
the hex end of Double Ended Allen key to
securely tighten the screws.
Installation of the
miter-lock knob (Fig . 3)
1. Locate the miter-lock knob among the
Loose Parts.
2. Assemble the miter-lock knob into the front
of the Table. Do Not Over Tighten.
Installation of the work clamp
(Fig .4)
The work clamp has specific groove heights
on the mounting stem for use with material
thicknesses within the capacity of this miter
saw. Use the maximum-height groove when
needing to clear the highest portion of the
adjustable fence. The maximum-height groove
supports clamping of workpieces between 2
½" and 3 ½" thick. The minimum-height groove
supports clamping of workpieces up to 2"
thick. The miter saw has two mounting holes
behind the fences for use when mounting the
workpiece clamp.
1. Insert the work clamp into the desired
mounting hole behind the fence.
2. Adjust the height of the clamp until the threaded stud of the work-clamp knob engages in
the selected groove. Do not lock.
18
Disconnect the plug from the power source before performing any
assembly, adjustment or repair to avoid possible injury .
Fig. 2
Fig. 3
Fig. 4
Minimum height
groove
Work-clamp knob
Two Screws
Carrying
handle
Knob
Maximum
height
groove