Assembly; Unpacking And Checking Contents; Tools Needed For Assembly And Alignment - Skil MS6305-00 Guide D'utilisation

ASSEMBLY

Unpacking and checking contents

WARNING
CAUTION
down position .
WARNING
wire connections could cause a fire.
Model MS6305-00 Sliding Miter Saw is shipped complete, in one box.
1. Separate all parts from Loose Parts list below to make sure that all items are accounted
for before discarding any packing material.
2. Loose Parts:
Work Clamp
•
Miter-Lock Knob
•
Double-Ended Allen Wrench
•
Dust Bag
•
Carrying Handle
•
Screws (2) for Assembling Carrying Handle, M6 X 65
•
Right Sliding Fence
•

Tools needed for assembly and alignment

Combination Square
(not supplied)
Combination square must be true - checking combination square
Should be no gap or overlap
when square is flipped over
in dotted position
If any parts are missing, do not plug in the power cord or turn the switch
on until the missing parts are obtained and are installed correctly .
Before moving the saw: Lock the miter-lock knob in the 45° left or 45°
right position . Lock the bevel-lock knob . Lock the head assembly in the
Never carry the tool by the cord or the head-assembly power-switch
handle . Damage to insulation could cause an electric shock. Damage to
Double-Ended Allen
Wrench, M6 Hex, with PH2
Phillips end (supplied)
Draw light line on board
along this edge
M5 Wrench
(not supplied)
Straight edge of board 3/4" thick.
This edge must be perfectly
straight
M4 Hex Wrench
(not supplied)
17