MINN KOTA 1810360 Manuel D'utilisation page 9

3
d. With the Flange Nuts in place, pull the Red Retainer
out to release the hardware. There are handles on
each side of the Red Retainer that can be used to
grasp each half. When pulling the Red Retainer,
grasp each side and pull so that the Red Retainer
breaks at the center and releases the hardware.
NOTICE:
The Mounting Holes on the Jack Plate
are slotted so that the Raptor can be adjusted along
the slots for the final installation.
e. With the Red Retainer removed, there is slack in
the mounting hardware between the Starboard
Jack Plate Bracket and Built-in Mounting Bracket.
This allows the Built-in Mounting Bracket and
Raptor to be rotated for final Raptor placement
along the Slotted Holes in the Starboard Bracket.
Check the angle of the bracket along the Slotted
Holes and confirm that the Raptor is set at the
desired angle. Once set, hold the hardware inside
the Jack Plate Bracket with a 9/16" Open End
Wrench. Tighten the Flange Nuts with a 9/16" Box
End or Socket Wrench. Do not over-tighten. Tighten
to 20 ft-lbs.
For warranty information, please visit
minnkotamotors.com
Part #2354910
minnkotamotors.com.
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
3d Handle Handle
Handle Handle
Red Red
Retainer Retainer Break Point Break Point
3e
Flange Nuts Flange Nuts
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
ECN 40715
3d
Red Red
Retainer Retainer
Break Break
Point Point
Handle Handle
Slotted Slotted
Starboard Starboard
Holes Holes
Bracket Bracket
©2020 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Rev B 06/20