Publicité
Les langues disponibles
Les langues disponibles
2.
Examine the Starboard side of your Jack Plate. Identify the
holes to be used for installation, if your Jack Plate does not
have pre-drilled holes ensure that you will not drill into any
obstructions and that the hardware will be accessible
for assembly.
3.
The Raptor must have a clear, unobstructed path to
operate. Check to make sure that your proposed location
will allow the anchor to deploy and retract without hitting
trim tabs, poling platforms, ladders, the engine or other
obstructions. You should also consider your fishing methods
when selecting the mounting location. Make sure that no
interference exists between the Raptor and your engine
during normal operation. With the location selected, trim
the engine all the way up and all the way down, and steer
the engine fully to the left and right to confirm proper
engine clearance. Ensure there is a minimum of two to
three inches of clearance from any point on the Raptor in
all states of stow and deploy.
4.
The bottom edge of the Raptor should never be less than
4" above the hull directly below the Raptor to prevent
spray and drag conditions. This applies to any mounting
configuration used.
5.
Keep the Red Retainer on the Jack Plate Bracket in place
during the installation until instructed to remove it. For all
installations paired with an additional bracket, the Jack Plate
Bracket must be installed prior to installing the Raptor or
additional brackets.
NOTICE:
If installing an additional bracket to the Jack
Plate Bracket, keep the Red Retainer in place and follow
the instructions included with the additional bracket. Do
not install the 3" Setback Bracket before completing the
installation of the Jack Plate Bracket to the Jack Plate.
6.
It may be necessary to remove a factory equipped E-ladder
for proper bracket installation. Due to the wide variety of
E-ladders, Minn Kota is not responsible for the re-installation or
re-location of any factory equipped E-ladder.
7.
Bob's Machine Shop Jack Plates require that holes be drilled
to accept the Adapter Bracket. A spacer kit must be used to
install correctly; see Minn Kota Spacer Block accessory Part
#1810212 or equivalent from Bob's Machine Shop.
NOTICE:
When mounting the Jack Plate Bracket to the Jack Plate it is recommended to review the additional mounting
considerations for the complete installation of the Raptor. They can be found online at
section of the Raptor Owner's Manual or Installation Instructions. They including how to mount the Hydraulic Pump and route the
Hydraulic Hoses along with other recommendations.
2 | minnkotamotors.com
NOTICE:
Check with your Jack Plate or Outboard
manufacturer to determine if additional hardware is
needed to accommodate installing this bracket. Longer
mounting bolts than originally provided by the outboard
manufacturer may be needed for proper installation.
Drilling holes may be required to accept the Jack Plate
Bracket and may void your manufacturer's warranty. Minn
Kota is not responsible for damages that may result.
2
Starboard
4
Bottom Edge
Bottom Edge
of Raptor
of Raptor
4" 4"
Minimum
Minimum
Hull directly
Hull directly
below Raptor
below Raptor
Complete Typical Installation
Outboard
Outboard
minnkotamotors.com
3
Raptor
Raptor
2" 2"
Minimum
Minimum
2"
2"
Minimum
Minimum
Outboard
Outboard
Motor
Motor
Raptor Range
Raptor Range
Range of
Range of
of Motion
of Motion
Motion
Motion
5
Red
Red
Retainer
Retainer
Jack Plate
Jack Plate
Bracket
Bracket
Transom
Transom
in the "Installation"
©2020 Johnson Outdoors Marine Electronics, Inc.
Publicité
