MINN KOTA 1810360 Manuel D'utilisation page 8

Completing the Installation
1
a. Begin with the Starboard Bracket already installed
to the Jack Plate. For specific instructions, please
refer to the installation for each type of Jack Plate
above. Once the Jack Plate Bracket is secured,
leave the hardware and Red Retainer in place until
instructed to remove it and continue below.
NOTICE:
person help with installation.
2
ITEM(S) NEEDED
b. With the help of a second person, position the
Built-in Mounting Bracket on the Raptor, so that
the hardware in the Red Retainer on the Starboard
Jack Plate Bracket aligns with the Mounting Holes
in the Built-in Mounting Bracket. Apply Anti-sieze
(Item #22) to the threads of the hardware held in
place by the Red Retainer. Then install the Built-in
Mounting Bracket to the hardware.
NOTICE:
hardware in the Jack Plate Bracket with the
Mounting Holes in the Built-in Mounting Bracket
to aide in installation. Keep the Red Retainer in
place until instructed to remove it.
c. Take four of the Flange Nuts (Item #20) and place
one on the end of each of the Hex Head Cap Screws.
Secure them loosely.
8 | minnkotamotors.com
It is recommended to have a second
#20 X 4
The Red Retainer helps to align the
1a
Outboard Outboard
Jack Plate Jack Plate
Hardware Hardware
Bracket Bracket
Red Red
Retainer Retainer
Transom Transom
#22 x 1
2b
Built-in Built-in Mounting Mounting
Mounting Bracket Mounting Bracket
Holes Holes
2c
Flange Flange
Nuts Nuts
Jack Plate Jack Plate
Built-in Built-in
Bracket Bracket
Mounting Bracket Mounting Bracket
1a
Hardware Hardware
Red Red
Jack Plate Jack Plate
Retainer Retainer
Bracket Bracket
Hardware Hardware
Retainer Retainer
Starboard Starboard
Red Red
Retainer Retainer
©2020 Johnson Outdoors Marine Electronics, Inc.
Outboard Outboard
Red Red
Bracket Bracket