MINN KOTA 1810360 Manuel D'utilisation page 5

Installation with a Slidemaster Manual Jack Plate
Support the Outboard before any work has begun on the bracket installation. An unsecured motor may cause harm from falling. Make
sure that all hardware is replaced and/or secure before moving or operating the boat or Outboard once installation is complete.
1
ITEM(S) NEEDED
a. Locate the Mounting Holes on the Starboard side of
the Slidemaster Manual Jack Plate. After supporting
the Outboard, remove the hardware that is holding
the Slide Bar and Inner Threaded Plate in place.
NOTICE:
Any existing Side Bar should be removed
and not reused. The Inner Threaded Plate that came
with the Jack Plate will be reinstalled.
b. Take the Starboard Jack Plate Bracket (Item #2 or
Item #4) and align it with the Mounting Holes in
the Starboard side of the Jack Plate. Orientate the
Starboard Bracket so that the Red Retainer is facing
Outboard and the Slotted Mounting Hole is upward.
Position the Inner Threaded Plate back in place.
2
ITEM(S) NEEDED
c. With the Starboard Bracket aligned, take two 3"
Stainless Steel Hex Head Cap Screws (Item #18)
and two Heavy Duty Stainless Steel Washers (Item
#14). Place one Heavy Duty Washer on each of
the Hex Head Cap Screws. Apply anti-seize on the
threads of the Hex Head Cap Screws (Item #22).
d. Insert the Hex Head Cap Screws with the Heavy
Duty Washers in place through the Mounting Holes
in the Starboard Bracket, then into the Holes on the
Starboard Side of the Jack Plate and then into the
Inner Threaded Plate.
e. Hold the Inner Threaded Plate in place and use a
1/2" Open End Wrench or Socket Wrench tighten
the Hex Head Cap Screws. Check with your specific
equipment manufacturer for their recommended
settings. Tighten hardware to 50 ft-lbs.
f. Continue to the "Completing the Installation" section
of these instructions.
5 | minnkotamotors.com
CAUTION
#2 x 1
#18 X 2 #14 x 2
#4 x 1
Inner Threaded Plate Inner Threaded Plate
1a
Mounting Bolts Mounting Bolts
Side Bar Side Bar
#22 x 1
2c
Inner Threaded
Outboard
Plate
Heavy Duty
Washers
Hex Head
Cap Screws
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Applying an anti-seize may help prevent seizing.
NOTICE:
The hardware on the inside of the Jack Plate is
secured into the Inner Threaded Plate. Two of the Heavy
Duty Stainless Steel Washers (Item #14) and two of the
Nylock Nuts (Item #16) will not be used.
1b
Inner Threaded
Red
Plate
Retainer
Mounting
Holes
Slotted
Mounting
Hole
Outboard
2e
Inner Threaded
Outboard
Plate
©2020 Johnson Outdoors Marine Electronics, Inc.