MINN KOTA 1810360 Manuel D'utilisation page 3

INSTALLATION
Installation to the Raptor Universal Sandwich Adapter
1
ITEM(S) NEEDED
a. This Starboard Jack Plate Bracket (Item #2 or Item
#4) will only be used to mount the Raptor to the
Universal Sandwich Adapter if it was installed so that
the Sandwich Bracket was oriented to the Starboard
side of the boat. If installed for a Starboard mount,
locate the Mounting Holes on the side of the
Sandwich Bracket.
b. Take the Starboard Jack Plate Bracket and align it
with the Mounting Holes in the Sandwich Bracket.
Orientate the Starboard Bracket so that the Red
Retainer is facing Outboard and the Slotted
Mounting Hole is upward.
2
ITEM(S) NEEDED
c. With the Starboard Bracket aligned, take two 3"
Stainless Steel Hex Head Cap Screws (Item #18)
and two Heavy Duty Stainless Steel Washers (Item
#14). Place one Heavy Duty Washer on each of
the Hex Head Cap Screws. Apply anti-seize on the
threads of the Hex Head Cap Screws (Item #22).
d. Insert the Hex Head Cap Screws with the Heavy Duty
Washers in place through the Mounting Holes in the
Starboard Bracket and into the Mounting Holes on
the Sandwich Bracket.
e. Take two Heavy Duty Stainless Steel Washers (Item
#14) and place one on the end of each Hex Head
Cap Screw on the opposite side of the Sandwich
Bracket. Secure the hardware with two Stainless
Steel Nylock Nuts (Item #16). Hold the Nylock Nuts
with a 1/2" Open End Wrench and tighten the Hex
Head Cap Screws with a 1/2" Socket Wrench. Check
with your specific equipment manufacturer for their
recommended settings. Tighten hardware to 50 ft-lbs.
f. Continue to the "Completing the Installation" section
of these instructions.
3 | minnkotamotors.com
#2 x 1
#18 X 2 #14 x 4
#4 x 1
1a
Universal Universal
Sandwich Sandwich
Adapter Adapter
Mounting Mounting
Holes Holes
Outboard Outboard
#16 x 2
2c
Starboard Starboard
Bracket Bracket
Mounting Mounting
Holes Holes
Heavy Duty Heavy Duty
Washers Washers
Hex Head Hex Head
Cap Screws Cap Screws
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Applying an anti-seize may help prevent seizing.
1b
Red Retainer Red Retainer
Starboard Starboard
Bracket Bracket
Mounting Mounting
Holes Holes
Slotted Slotted
Mounting Mounting
Hole Hole
Outboard Outboard
#22 x 1
2e
Heavy Duty Heavy Duty
Washers Washers
Nylock Nylock
Nuts Nuts
Starboard Starboard
Bracket Bracket
©2020 Johnson Outdoors Marine Electronics, Inc.