Publicité
Les langues disponibles
Les langues disponibles
Installation with a Bob's Machine Shop Jack Plate
Installation of the Side Mount Adapter Bracket into a Bob's Machine Shop Jack Plate requires Spacer Block Kit 1810212.
1
ITEM(S) NEEDED
a.
Locate the Mounting Holes on the Starboard side
of the Bob's Machine Shop Jack Plate. For Bob's
Machine Shop Jack Plates use Spacer Block Kit
1810212. Refer to the Installation Instructions
provided with the Spacer Block Kit for more details.
b.
Take the Starboard Jack Plate Bracket (Item #2 or
Item #4) and align it with the Mounting Holes in
the Starboard side of the Jack Plate. Orientate the
Starboard Bracket so that the Red Retainer is facing
Outboard and the Slotted Mounting Hole is upward.
2
ITEM(S) NEEDED
c.
With the Starboard Bracket and Spacer Block
aligned, take two 3" Stainless Steel Hex Head Cap
Screws (Item #18) and two Heavy Duty Stainless
Steel Washers (Item #14). Place one Heavy Duty
Washer on each of the Hex Head Cap Screws. Apply
anti-seize on the threads of the Hex Head Cap
Screws (Item #22).
d.
Insert the Hex Head Cap Screws with the Heavy Duty
Washers in place through the Mounting Holes in the
Starboard Bracket and Spacer Block and into the
Holes on the Starboard Side of the Jack Plate.
e.
Take two Heavy Duty Stainless Steel Washers (Item
#14) and place one on the end of each Hex Head
Cap Screw on the inside of the Jack Plate. Secure
the hardware with two Stainless Steel Nylock Nuts
(Item #16). Hold the Nylock Nuts with a 1/2" Open
End Wrench and tighten the Hex Head Cap Screws
with a 1/2" Socket Wrench. Check with your specific
equipment manufacturer for their recommended
settings. Tighten hardware to 50 ft-lbs.
f.
Continue to the "Completing the Installation" section
of these instructions.
7 | minnkotamotors.com
#2 x 1
#18 X 2
#14 x 4
#4 x 1
1a
Outboard
Slotted
1a
Red
Mounting Hole
Retainer
Outboard
Starboard
Bracket
#16 x 2
Starboard
2c
Bracket
Heavy Duty
Washers
Mounting
Mounting
Holes
Holes
Hex Head
Cap Screws
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Applying an anti-seize may help prevent seizing.
1a
Spacer Block
Mounting
Holes
Jack Plate
Spacer Block
#22 x 1
Nylock Nut
2e
Outboard
Heavy Duty
Washers
Heavy Duty
Nylock
Washers
©2020 Johnson Outdoors Marine Electronics, Inc.
Nut
Publicité
