Dexter 20VOS2-125.1 Mode D'emploi page 191

Les langues disponibles

6. MAINTENANCE

The orbital sander and charger is designed for using and charging in temperature regions with a

characteristic temperature of 0 ° C to 50 ° C, relative humidity not more than 80%,the absence of

direct exposure to atmospheric pre capitation and excessive dust content of the air.

Requirements for room conditions

Do not use power tools in explosive areas where flammable liquids, gases, dust are present. It creates

sparks, which can lead to the ignition of dust, steam.

Shelf life - 4 years provided that the products are stored indoors with natural ventilation in the

package at an air temperature of --20 ° C to 40 ° C and a relative humidity of not more than 80%

7.TROUBLE SHOOTING

Problem

The machine stops working

after rotating slowly.

Sparking visible through the

housing air vents

Selecting the correct grit of sandpaper is an important step in achieving optimum results. Coarse

grit will remove the most material. Finer grit will produce a smoother finish. The condition of the

workpiece will determine the grit of the sandpaper to be used. The higher the grit number, the finer

the grade of sandpaper.If the surface is rough, start with a coarse grit and sand until the surface is

uniform. Medium grit may then be used to remove scratches left by the coarser grit. Finer grit is then

used to finish the surface. Always continue sanding with each grade of sandpaper until the surface

is uniform.

Application area

Storage conditions

Possible Causes

The battery is in low power.

A small amount of sparking

may be visible through the

housing vents.

Sandpaper Selection

Likely solutions

Need to charge the battery

pack before operating

This is normal and does not

indicate a problem.

191