CAPITAL SPORTS Laufband Pacemaker X20 Mode D'emploi page 44

before additional re-lubing is necessary.
CAUTION: Unplug the device before starting with maintenance and care.
General Cleaning
• Use a soft, damp cloth to wipe the edge of the belt and the area between the belt edge and frame.
A mild soap and water solution along with a nylon scrub brush will clean the top of the textured belt.
This task should be done once a month. Allow to dry before using.
• On a monthly basis, vacuum underneath your treadmill to prevent dust build up. Once a year, you
should remove the black motor shield and vacuum out dirt that may accumulate.
General Care
• Check parts for wear before use.
• Always replace the mat if worn and any other defective parts.
• If in doubt do not use the treadmill and contact our helpline.
Belt Adjustment
Belt tension adjustment. It is very important for joggers and runners in order to provide a smooth, steady
running surface. Adjustment must be made from the right and left rear roller in order to adjust tension with
the hexagonal wrench provided in the parts package. The adjustment bolt is located at the end of the rails
as noted in diagram below.
Note: Adjustment is through the small hold on the end caps.
44