Sony SU-XFQ005 Guide De L'utilisateur page 7

Install the Display Unit
WARNING
A short circuit or an electric shock may result if the
AC power cord is pinched under the footing of the
stand or between other equipment.
If you stumble over the AC power cord or the
display interface cable, the stand may topple over
and cause injury.
Decide on the installation location and lay the
stand down before installing the Display Unit.
Since the Display Unit is heavy, it is recommended
that you decide on the installation location first,
and then lay the Floor Stand down before installing
the Display Unit.
Note
Do not drag the Floor Stand while it is on the floor. The
rubber footings on the base of the Floor Stand may come
off.
1
Attach the Display Unit to the
Floor Stand.
Use the screw alignment holes on the rear of the
Display Unit as guides. Gently lower the Display
Unit to align the holes of the screws over the
joints of the Floor Stand.
Rear of Display Unit
Bottom of Display Unit
Joint
This Display Unit has
finger slots on both sides
at the bottom for holding.
z Hint
There are finger slots located at the bottom of the
Display Unit on both sides for holding. When
attaching the Display Unit to the stand, use the slot to
support the bottom and hold the top with your other
hand.
The caution label is on the front
side of the Floor Stand.
Holes for the display
securing screws
Guides
5
(US)
US