Fellowes Powershred P-48C Mode D'emploi page 3

BASIC SHREDDING OPERATION
PAPER/CARD
1
Continuous operation:
Up to 5 minutes maximum
NOTE: Shredder runs briefly
Plug in and put
after each pass to clear entry.
disconnect power
Continuous operation beyond
switch in ON (I) position
5 minutes will trigger a
30-minute cool down period.
Safety Lock prevents accidental operation.
To unlock push black button down and slide toward back of shredder. For greater safety, always unplug shredder after use.
PRODUCT MAINTENANCE
OILING SHREDDER
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
PAPER JAM
1 2
Set to Reverse (R) Alternate slowly back and forth
for 2-3 seconds
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 2 years from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be
free from defects in material and workmanship for 3 years from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole and
exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product
usage standards, shredder operation using an improper power supply (other than listed on
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
2 3
Set to Auto-On (I) Feed paper/card
straight into paper
entry and release
To set, wait for shredding to stop, push black button down and slide towards front of shredder.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
Set to Off (O) * Apply oil
across entry
3 4
Set to Off (O)
and unplug
4
When finished shredding
set to OFF (O)
3
Set to Reverse (R)
for 2-3 seconds
6
5
Gently pull uncut Set to Auto-On (I) and
paper from paper resume shredding
entry. Plug in.
additional costs incurred by Fellowes to provide parts or services outside of the country where the
shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION
TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable
specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
more details or to obtain service under this warranty, please contact us or your dealer.
Shredder doesn't start:
Make sure head is on basket correctly
Wait 30 minutes for motor to cool down
Remove and empty basket
Make sure safety lock is in
unlock position
3