Philips AVENT SCD510 Mode D'emploi page 11

parent unit
Battery operation (rechargeable battery pack)
The parent unit comes with a SCD510 NiMH rechargeable battery pack.
Charge the parent unit before you use it for the first time or when the battery light indicates that
the battery pack is low. The battery light flashes red when the battery pack is low. The battery light
starts to flash red 30 minutes before the battery pack is completely empty.
Note: If the battery pack is completely empty, the parent unit automatically switches off and loses
contact with the baby unit.
1 Remove the lid of the compartment for the rechargeable battery pack (Fig. 8).
2 Insert the rechargeable battery pack (Fig. 9).
Note: Make sure the + and - poles of the battery pack point in the right direction.
3 Reattach the lid (Fig. 10).
4 Put the small appliance plug in the parent unit and put the adapter in a power outlet (Fig. 11).
5 Leave the parent unit plugged in until the battery pack is fully charged.
During charging, the battery light lights up red continuously.
,
When the battery pack is fully charged, the battery light lights up green continuously.
,
- When you charge the parent unit for the first time or after a long period of non-use, switch it
off and let it charge continuously for at least 10 hours.
- Charging normally takes 8 hours, but it takes longer when the parent unit is switched on while
charging. To keep the charging time as short as possible, switch off the parent unit during
charging.
- When the battery pack is fully charged, the parent unit can be used cordlessly for at least
24 hours.
Note: When the parent unit is charged for the first time, the operating time is less than 24 hours. The
battery pack only reaches its full capacity after you have charged and discharged it four times.
Note: When the parent unit is not connected to a power outlet or even when the parent unit is switched
off, the battery pack gradually discharges.
Using the appliance
Use the baby monitor for its intended household use as described in this manual.
1 Place the parent unit and the baby unit in the same room to test the connection (Fig. 12).
Make sure the baby unit is at least 3.5 feet/1 meter away from the parent unit.
2 Press and hold the on/off button 3 on the baby unit until the green power-on light
goes on. (Fig. 13)
Note: The power-on light always lights up green, even when there is no connection with the parent unit.
The nightlight lights up briefly and then goes out again.
,
The battery light T lights up briefly and then goes out again.
,
3 Press and hold the on/off button 3 on the parent unit until the sound level lights light up
briefly. (Fig. 14)
The battery light briefly lights up red and then lights up continuously (Fig. 15).
,
The LINK light flashes red. (Fig. 16)
,
The LINK light on the parent unit turns green and lights up continuously when a connection
,
has been established between the baby unit and parent unit (Fig. 17).
If no connection is established, the LINK light on the parent unit stops flashing and lights up
,
red. The parent unit beeps from time to time. (Fig. 18)
EngliSh
11