Klarstein CLEANBUTLER 3G TURBO Mode D'emploi page 18

EN
18
Attaching the floor brush to the housing
1. Connect the opening of the floor brush to the opening in the housing. When
you hear a clicking sound, the housing is properly connected to the floor
brush.
2. To remove the floor brush, press the floor brush release button with one
hand. At the same time, hold the floor brush with your other hand and pull it
out of the housing opening.
Charging the battery
1. Connect the charging cable to the device as shown in the illustration
and insert the mains plug of the charger into the socket. The device will
automatically start charging.
2. When the charging indicator is flashing green, it means that the battery is
still charging. When the charging indicator lights up green continuously, the
battery is fully charged. When the green light goes out, it means the battery
status is reduced. This can cause the device to not work properly. When the
charging indicator starts flashing red, the device needs to be charged.
Note: Remove the vacuum cleaner tube before charging the device.
Charging indicator