Rowenta VITALITY Notice D'emploi page 15

OPERATION
Before switching on your appliance, make sure that:
- the appliance is positioned in accordance with these instructions,
- the air inlet and outlet grills are completely unobstructed,
- the appliance is placed on a flat and stable surface.
START-UP OF THE APPLIANCE
Plug the lead in and press the start button ( ).
On the display, the pictogram (L) appears indicating the temperature and relative humidity of the
room, as well as the speed and humidity selected the last time the appliance was used.
Note: If the appliance is not in continuous operation, the compressor will only work if the humidity
factor selected is lower than the room.
HUMIDITY CONTROL Function
To set the target relative humidity, select one of the values, 70%, 60% or 50%, using the button (B).
If the 70% function is selected, this means that the air will be dehumidified until the relative humidity
falls to 70%. The appliance will turn off automatically if the relative humidity is below 70% (the com-
pressor will stop but the fan will continue to operate). The compressor will start again if the relative
humidity exceeds 70%.
The same applies if 60% or 50% is selected.
CONTINUOUS function
The unit dehumidifies the room continuously if the CONTINUOUS function (O) is activated using
button (B), regardless of the ambient humidity.
SPEED Function
Press button (C) to select:
• « » : gentle ventilation
• « » : medium ventilation
15
GB