Blumfeldt 10032517 Mode D'emploi page 15

Electric Safety
• Do not plug the appliance into a wall outlet until the appliance has been
fully assembled.
• Do not use the appliance if the power cord or plug is damaged. The heater
must be securely grounded when in use.
• The heater should be plugged in a socket, which is easily visible and
reachable.
• If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
• Do not wind the power cable around the unit.
• If the heater gets damaged, it must be repaired by professional
electricians.
• Do not use this heater with a programmer, timer, separate remote-control
system or any other device that switches the heater on automatically,
since a fire risk exist if the heater is covered or positioned incorrectly.
Mounting
• Mount the heater outside or in a large open area and well away from any
obstructions such as branches or where the heater is near any objects that
can be affected by heat, such as furniture, curtains or other inflammable
objects (minimum distance 1 meter).
• Mount the heater securely on a firm, level ceiling surface.
• The appliance is only suitable for household use. It is not safe to install the
appliance on construction sites, in greenhouses, barns or stables, as easily
flammable dust is formed.
• If the heaters are placed in areas where spray painting of any description
is taking place, they should not be used during the painting operations.
Never use the heater in particularly dusty and explosive areas.
• Do not position immediately above or below an electrical socket.
• The unit must be placed with the clearance of 180 cm to the floor and
50 cm to the ceiling.
• When assembling, keep away from any board or flammable material.
EN
15