Assembly; To Assemble The Handle; To Install The Trimmer Guard; To Install The Blade Guard - Meec tools 000903 Traduction Des Instructions D'origine

● Do not overfill the fuel tank. Tighten the fuel cap carefully
after refuelling.
● Never refuel the product while the engine is on.
● If you have spilled fuel on the product, wipe off the
spillage and allow remaining fuel to evaporate. Move the
product 10 m from the place where you spilled the fuel.
● If you have spilled fuel on yourself or on your clothes,
change your clothes and wash any part of your body that
has come in contact with fuel. Use soap and water.
● Regularly do a check for leaks from the fuel tank, fuel cap
and fuel lines.
● Store the fuel in approved containers for petrol.
3

Assembly

Warning! Before you assemble the product, you must
read and understand the safety chapter.
Warning! Remove the spark plug cable from the
spark plug before you assemble the product.

3.1 To assemble the handle

1
Put the spring (A) in the bracket of the shaft.
(Figure 2)
2
Assemble the handle according to the illustration.
3
Tighten the knob.

3.2 To install the trimmer guard

1
Put the trimmer guard on the gear housing. (Figure 3)
2
Install the screws.

3.3 To install the blade guard

1
Put the blade guard on the gear housing. (Figure 4)
2
Install the screws.

3.4 To install the trimmer line

1
Use a hex key (A) to lock the bracket. (Figure 5)
2
Use a socket spanner (B) to loosen the nut.
3
Remove the support cup.
38
4
Put the trimmer line on the axle with the bracket
locked. (Figure 6)
5
Rotate the trimmer line counterclockwise.
6
Attach the trimmer guard. Refer to "3.2 To install the
trimmer guard" on page 38.

3.5 To install the clearing blade

1
Use a hex key (A) to lock the bracket. (Figure 5)
2
Use a socket spanner (B) to loosen the nut.
3
Remove the support cup.
4
Assemble according to the illustration with the
bracket locked. (Figure 7)
5
Rotate the support cup counterclockwise.

3.6 To install the saw blade

1
Use a hex key (A) to lock the bracket. (Figure 5)
2
Use a socket spanner (B) to loosen the nut.
3
Remove the support cup.
4
Assemble according to the illustration with the
bracket locked. (Figure 8)
5
Attach the blade guard. Refer to "3.3 To install the
blade guard" on page 38.
Warning! Never use the saw blade if the blade guard
is not attached.

3.7 To attach the harness

1
Put on the harness on your shoulders.
2
Close the buckle.
3
Connect the product to the harness.
4
Pull the strap on the harness to adjust the weight of
the product equally on your shoulders.
5
Adjust the harness until the cutting attachment is
parallel to the ground.
2022_001