Sigma ROX GPS 11.0 Mode D'emploi page 12

3. Before initial use
NOTE
Fully charge the ROX GPS 11.0.
Charge the device using the micro USB cable and the USB port on your PC. Alternatively,
use the USB charger. The process takes approximately 3 hours. To charge the device,
plug the USB cable into the micro USB port on the back of the ROX GPS 11.0 and the
USB port on your PC or the USB charger (not included in the delivery).
3.1 Initial use
1. Press and hold the START button for 5 seconds (right upper button).
2. Press START to change the language.
3. Now press the PLUS or MINUS buttons to select your desired language and then
press the START button.
4. Configure the remaining settings using the same principle.
3.2 Pairing the sensors (ANT+) with the ROX GPS 11.0
To use the sensors (ANT+), these must be paired with the ROX GPS 11.0.
To carry out the pairing, select the menu item SETTINGS ---> CONNECT SENSOR.
There are several options to pair the sensors:
− With SELECT SENSOR, you can search for a certain type of sensor.
− With SEARCH ALL, you can search for all the sensors in the area.
− Enter the sensor ID, if it is known.
Always make sure before you start the search that only the sensors that are to be
paired are activated.
Start the search using SEARCH ALL or SEARCH SENSOR ---> desired sensor type.
After a few seconds, the sensor and the associated sensor ID are displayed. Select the
desired sensor to connect.
The sensors that are paired can be found under CONNECTED SENSORS.
3.3 Synchronisation of the sensors
To synchronise the sensors (ANT+), the ROX GPS 11.0 must be switched on and in
training mode.
The sensor search takes place automatically. It searches for all previously paired
sensors. The respective value for the sensor stops flashing as soon as the
corresponding sensor has been found.
If a sensor is not found, make sure that it is activated.
3.4 Connect to your smartphone
In order to transfer the training data to the SIGMA LINK app, first pair your smartphone
with the ROX GPS 11.0. To do so, select the following menu item:
SETTINGS ---> SMARTPHONE CONNECTION ---> CONNECT SMARTPHONE.
Follow the instruction of the SIGMA LINK app.
4. Operation / Button functions / Menu overview
4.1 Operating concept
A continually visible navigation level makes the ROX GPS 11.0 menu navigation far
easier for the user. The possible functions of the STOP and START buttons are displayed
in this level to:
− Go to the next level down (START),
− Go back to the next level up (STOP),
− To scroll within the menu level forward or backward or to increase or reduce values
(PLUS or MINUS)
12