Certification Information - EXFO FOT-10A Manuel D'instructions

C I
ERTIFICATION NFORMATION
C I
ERTIFICATION NFORMATION
This unit has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
unit generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this unit does cause harmful interference to radio
or television reception, which can be determined by turning the unit off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by EXFO Electro-Optical
Engineering could void the user's authority to operate the equipment.
INDEPENDENT LABORATORY TESTING
This unit has undergone extensive
and externally, at an independent, qualified laboratory. All pre-qualification tests were
performed at EXFO while all final tests were performed at UltraTech Engineering
Labs, Inc., a renowned test laboratory from Mississauga, Canada. This guarantees the
unerring objectivity and authoritative compliance of all test results.
This equipment has been tested and found to comply with the limits for a Class B digi-
tal device. Please see the Declaration of Conformity.
F.C.C. INFORMATION TO USER
WARNING
certification testing both internally, at EXFO,
INFORMATION TO USER
iv