Back Installation; Installing The Mount Hardware - Physipro HP2 Mode D'emploi

ENGLISH
Table 3 – Sizes associated to the HP2 back Sport model
Actual Plate
Width
11'' (27.5 cm) 12'' (30 cm)
13'' (33 cm) 14'' (35 cm)
15'' (38 cm) 16'' (40 cm)
17'' (43 cm) 18'' (45 cm)

5. Back installation

Please read the following instructions before beginning installation.
The following steps explain how to fully install the HP2 back. The installer should follow
the steps in the prescribed order.
Tools required 4 mm Allen key

5.1 Installing the mount hardware

When you receive your back, this step will already be done by our technicians.
However, this procedure will help you put it together again.
1. Insert bolt A in the dedicated
hole and make sure the washer
B is inserted between the bolt
and the back.
2.
Put the nut C in place, but do
not tighten it, because the
receptacle needs to move easily
in the groove.
3.
Repeat steps 1 and 2 with bolts
D, E, F and G.
Here is what it should look like:
Note that, at this moment, the receptacle is not tightly fastened to
the back. It can move up and down as well as sideways. It will be
securely fastened in a subsequent step (5.2) when the back will be
positioned correctly in the anchors.
Nominal Nominal
Width Heigth
9'' (23 cm)
9'' (23 cm)
9'' (23 cm)
9'' (23 cm)
Associated
Wheelchair Width
12 to 13'' (30 to 32.5 cm)
14'' to 15'' (35 to 38 cm)
16'' to 17'' (40 to 43 cm)
18'' to 19'' (45 to 48 cm)
D
E
6
HP2 Back
Associated Wheelchair
Width With Extension
Option
14'' (35.5 cm)
16'' (40.5 cm)
18'' (46 cm)
20'' (51 cm)
C
B
A
F
G