Télécharger Imprimer la page

Bestway SaluSpa Instructions page 7

Masquer les pouces Voir aussi pour SaluSpa:

Publicité

Les langues disponibles

Les langues disponibles

GFCI Test
IMPORTANT: RISK OF ELECTRIC SHOCK. THE GFCI MUST BE TESTED
BEFORE TURNING ON THE PUMP EACH TIME.
1. Plug the GFCI into a power outlet, the indicator turns red.
2. Press the test button, the indicator turns off.
3. Press the reset button again, the indicator turns red and the spa is ready for use.
WARNING: The GFCI plug must be tested before each use to avoid risk of electric
shock.
WARNING: Before inserting plug into a power outlet, make sure the current rate of
the power outlet is suitable for the pump.
WARNING: Do not use the pump if this test fails and contact our Aftersales Service.
NOTE: When inflating, you will notice that air will be
expelled from the area where the air hose connects to the
pump, this is normal for technique requirements.
NOTE: Do not use an air compressor to inflate the pool.
NOTE: Do not drag the pool on rough ground as this may
cause damage to the pool liner.
NOTE: Inflation time for reference only.
Air Valve Check
(for spa with quick inflation/deflation valve)
Always check the air valve carefully before inflation to ensure there is
not an air leak. If the air valve is loose, use the provided wrench to
fasten the air valve following these steps:
With one hand, hold the backside of the air valve from the inner side of
the spa wall and turn the wrench clockwise.
NOTE:
1. Do not over tighten.
2. Do not adjust the air valve connector when the spa is
in use.
7

Publicité

loading