Bestway SaluSpa Instructions page 6

NOTE: The warning label must be posted near your spa in a readable position
during using your spa.
1. Take out the warning label from the accessory kit.
2. Carefully peel the warning label.
3. Affix the warning label.
To order the warning label, please contact your local Coleman After Sales Service.
To reach 104°F (40°C), the heating duration required is base on the starting water
temperature and ambient temperature, the data below is purely for reference. To display
the current water temperature, run the filter system for at least a minute.
Ambient Temperature
50°F
59°F
68°F
77°F
86°F
Be sure to cover the spa with the spa cover whenever the heating function is
activated. Leaving the spa uncovered will inrease the heating duration required.
Please do not use the spa when ambient temperature is lower than 39°F.
Power Rate
110-120V AC,
12A at 20ºC
Assembly part refer to the provided installation leaflet.
INSTALLATION
Selected Location
IMPORTANT: Because of the combined weight of the SaluSpa, water, and users, it is
extremely important that the base where the SaluSpa is installed is smooth, flat, level and
capable of uniformly supporting the weight for the entire time the SaluSpa is installed (not on
the carpet or other similar material). If the SaluSpa is placed on a surface, which does not
meet these requirements, any damage caused by improper support is not covered under the
manufacturer's warranty. It is the responsibility of the SaluSpa owner to assure the
integrity of the site at all times.
1. Indoor Installation:
Be aware of special requirements if you install the spa indoors.
• Humidity is a natural side effect with SaluSpa installation. Determine the effects of moisture on exposed wood,
paper, etc. in the proposed location. To minimize these effects, it is best to provide plenty of ventilation to the
selected area. An architect can help determine if more ventilation is needed.
2. Outdoor Installation:
• During filling, draining or when in use, water may spill out of the spa. Therefore the SaluSpa should be installed
near a floor drain.
• Do not leave the spa's surface exposed to direct sunlight for long periods of time.
IMPORTANT !
Water Temperature
50°F
59°F
68°F
77°F
86°F
Massage Tube Power
6.5A
Set Temperature
104°F
104°F
104°F
104°F
104°F
Heat Element Power
11.3A at 20ºC
6
Heating Duration
32 h
26 h
20 h
14 h
9 h
Water Pump Power
0.7A